Rockford Fosgate T400-4

Cod produs: T400-4

Stare produs: Nou

Amplificator pe 4 canale, putere 200W RMS in punte pe 2 canale sau 60W RMS x 4 canale, clasa A/B, MOSFET, filtre high-end si low-pass 50-500Hz, bass / treble variabil

More details

Avantaje CarSound:

Peste 10 ani experienta
Consultanta de specialitate
Instalare produse
Preturi de importator
*Livrare gratuita la comenzi de peste 200ron

Cumpara de minim 200,00 lei si beneficeaza de TRANSPORT GRATUIT!

Carsound ofer livrare gratuita pentru comenzi de peste 200 ron

Detalii si comenzi la 0735.100.200

307.41 Lei x 4 rate

Amplificator auto pe 4 canale
60 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)
200 watts RMS x 2 bridged output at 4 ohms (2-ohm stable in bridged mode)
Dynamic Thermal Management cooling system
Differential Input circuitry eliminates hum
variable high- and low-pass filters (50-500 Hz, 24 dB/octave)
variable bass/treble boost (0-18 dB at 45 Hz, 0-12 dB at 12k Hz)
optional remote bass/treble boost (available soon)
Class-AB amplifier design
MOSFET power and output stages
preamp inputs
4-gauge power and ground leads and a 100-amp fuse recommended — wiring and hardware not included with amplifier
no on-board fuses — when installing multiple amps in a system, an additional 100-amp in-line fuse between the distribution block and the amplifier is recommended
13-5/8"W x 2-1/4"H x 9-5/8"D

Dynamic Thermal Management

Power Series amps use Rockford Fosgate's patented, award-winning "Dynamic Thermal Management," a 3-stage cooling system that uses forced air to dissipate heat evenly across the amp and out through the large heatsinks. This results in cooler internal components, higher efficiency, and lower distortion.

Even heat dispersal for longer life

EHSA cooling process

Maximum Efficiency Heat Sink Application increases heat transfer away from the transistors

MEHSA is a Rockford Fosgate proprietary process that increases the heat transfer from the MOSFET devices to the heatsink. This allows the heat to escape more readily from the amplifier, so that the transistors stay cooler.

Extra-quiet inputs

Differential Inputs prevent noise from entering

"Differential Input" circuitry helps eliminate any electronically induced noise or hum that could be picked up by the input cables, allowing only clean signals to enter the amplifier. You get more music with less heat and noise in a stylish package that's up to 40% smaller than previous models.

T400-4 Power performance

The T400-4 amplifier puts out 60 watts RMS into each of its four channels — more than enough to drive your front and rear speakers to their musical peaks. Or you can bridge your T400-4 to blast 200 watts each to a pair of subwoofers. Either way, you can depend on clean, powerful sound from your Power Series amp.